On 27 Jun 2024, at 09:26, Michał Markowski <markowski1@gmail.com> wrote:
> 
> On 5 Jun 2024, at 11:25, Michał Markowski <markowski1@gmail.com> wrote:
>> 
>> On 4 Jun 2024, at 14:41, Stuart Henderson <stu@spacehopper.org> wrote:
>>> This takes some lines above 80 columns (against KNF). But also means
>>> that these log messages are unusable without recompile. When getting
>>> things setup for sync in the first place I think they are useful so,
>>> if changing anything, I think I'd just change this from log_info to
>>> log_debug without the extra conditional.
>> 
>> Good point, this way you can still check sync status using “dhcpd -dv” during initial setup.
>> 
>> diff --git a/usr.sbin/dhcpd/sync.c b/usr.sbin/dhcpd/sync.c
>> index 1f701f60d46..19e9d2c1145 100644
>> --- a/usr.sbin/dhcpd/sync.c
>> +++ b/usr.sbin/dhcpd/sync.c
>> @@ -307,7 +307,7 @@ sync_recv(void)
>>   sizeof(lp->ip_addr));
>> memcpy(&lp->hardware_addr, &lv->lv_hardware_addr,
>>   sizeof(lp->hardware_addr));
>> - log_info("DHCP_SYNC_LEASE from %s for hw %s -> ip %s, "
>> + log_debug("DHCP_SYNC_LEASE from %s for hw %s -> ip %s, "
>>   "start %lld, end %lld",
>>   inet_ntoa(addr.sin_addr),
>>   print_hw_addr(lp->hardware_addr.htype,
>> @@ -431,7 +431,7 @@ sync_lease(struct lease *lease)
>> memcpy(&lv.lv_ip_addr, &lease->ip_addr, sizeof(lv.lv_ip_addr));
>> memcpy(&lv.lv_hardware_addr, &lease->hardware_addr,
>>   sizeof(lv.lv_hardware_addr));
>> - log_info("sending DHCP_SYNC_LEASE for hw %s -> ip %s, start %d, "
>> + log_debug("sending DHCP_SYNC_LEASE for hw %s -> ip %s, start %d, "
>>   "end %d", print_hw_addr(lv.lv_hardware_addr.htype,
>>   lv.lv_hardware_addr.hlen, lv.lv_hardware_addr.haddr),
>>   piaddr(lease->ip_addr), ntohl(lv.lv_starts), ntohl(lv.lv_ends));
>> 
> 
> ping

ping