Download raw body.
On Sat, Aug 24, 2024 at 10:26:47AM +0200, Florian Obser wrote:
> The log in the first email looked pretty noisy. Not a user of dhcpd
> sync, but nobody spoke up that they totally need the noisy log, so
> OK florian
Go for it. OK claudio as well
> On 2024-06-05 11:25 +02, Michał Markowski <markowski1@gmail.com> wrote:
> > On 4 Jun 2024, at 14:41, Stuart Henderson <stu@spacehopper.org> wrote:
> >> This takes some lines above 80 columns (against KNF). But also means
> >> that these log messages are unusable without recompile. When getting
> >> things setup for sync in the first place I think they are useful so,
> >> if changing anything, I think I'd just change this from log_info to
> >> log_debug without the extra conditional.
> >
> > Good point, this way you can still check sync status using “dhcpd -dv” during initial setup.
> >
> > diff --git a/usr.sbin/dhcpd/sync.c b/usr.sbin/dhcpd/sync.c
> > index 1f701f60d46..19e9d2c1145 100644
> > --- a/usr.sbin/dhcpd/sync.c
> > +++ b/usr.sbin/dhcpd/sync.c
> > @@ -307,7 +307,7 @@ sync_recv(void)
> > sizeof(lp->ip_addr));
> > memcpy(&lp->hardware_addr, &lv->lv_hardware_addr,
> > sizeof(lp->hardware_addr));
> > - log_info("DHCP_SYNC_LEASE from %s for hw %s -> ip %s, "
> > + log_debug("DHCP_SYNC_LEASE from %s for hw %s -> ip %s, "
> > "start %lld, end %lld",
> > inet_ntoa(addr.sin_addr),
> > print_hw_addr(lp->hardware_addr.htype,
> > @@ -431,7 +431,7 @@ sync_lease(struct lease *lease)
> > memcpy(&lv.lv_ip_addr, &lease->ip_addr, sizeof(lv.lv_ip_addr));
> > memcpy(&lv.lv_hardware_addr, &lease->hardware_addr,
> > sizeof(lv.lv_hardware_addr));
> > - log_info("sending DHCP_SYNC_LEASE for hw %s -> ip %s, start %d, "
> > + log_debug("sending DHCP_SYNC_LEASE for hw %s -> ip %s, start %d, "
> > "end %d", print_hw_addr(lv.lv_hardware_addr.htype,
> > lv.lv_hardware_addr.hlen, lv.lv_hardware_addr.haddr),
> > piaddr(lease->ip_addr), ntohl(lv.lv_starts), ntohl(lv.lv_ends));
> >
>
> --
> In my defence, I have been left unsupervised.
>
--
:wq Claudio