On Wed, Nov 20, 2024 at 09:28:51PM +0100, Matthieu Herrb wrote:
> On Sat, Nov 16, 2024 at 07:59:29PM +0100, Landry Breuil wrote:
> > new diff after miod@ pointed out i had forgotten a break..
> 
> On an eaton 1200 ECO I get:
> 
> hw.sensors.upd0.acvolt0=-26.00 VAC (VoltageAc), OK
> hw.sensors.upd0.power0=1600.00 W (ConfigApparentPower), OK
> hw.sensors.upd0.indicator0=On (Charging), OK
> hw.sensors.upd0.indicator1=Off (Discharging), OK
> hw.sensors.upd0.indicator2=Off (NeedReplacement), OK
> hw.sensors.upd0.indicator3=Off (ShutdownImminent), OK
> hw.sensors.upd0.indicator4=On (ACPresent), OK
> hw.sensors.upd0.indicator5=Off (Overload), OK
> hw.sensors.upd0.percent0=87.00% (RemainingCapacity), OK
> hw.sensors.upd0.percent1=100.00% (FullChargeCapacity), OK
> hw.sensors.upd0.percent2=0.00% (PercentLoad), OK
> hw.sensors.upd0.timedelta0=2405.689200 secs (RunTimeToEmpty), OK
> 
> The 1st line (VolatageAC) seems wrong. It looks  like the inverse of a
> plausible VoltageDc (2 * 12V batteries in serial)
> 
> The other values look ok.
> 

After disconnecting the 230V cord :

hw.sensors.upd0.acvolt0=-26.00 VAC (VoltageAc), OK
hw.sensors.upd0.power0=1600.00 W (ConfigApparentPower), OK
hw.sensors.upd0.indicator0=Off (Charging), OK
hw.sensors.upd0.indicator1=On (Discharging), OK
hw.sensors.upd0.indicator2=Off (NeedReplacement), OK
hw.sensors.upd0.indicator3=Off (ShutdownImminent), OK
hw.sensors.upd0.indicator4=Off (ACPresent), OK
hw.sensors.upd0.indicator5=Off (Overload), OK
hw.sensors.upd0.percent0=88.00% (RemainingCapacity), OK
hw.sensors.upd0.percent1=100.00% (FullChargeCapacity), OK
hw.sensors.upd0.percent2=0.00% (PercentLoad), OK
hw.sensors.upd0.timedelta0=2433.340800 secs (RunTimeToEmpty), OK

I'm not sure if it's OK to have ACPresent=Off ... but may be the
sysctl OK only means that there was no error reading the sensor ?


-- 
Matthieu Herrb