On Sun, 19 Apr 2026 21:49:41 +0200,
Marcus Glocker <marcus@nazgul.ch> wrote:
> 
> Without sending HTT SRNG setup messages for the receive rings, the
> WCN7850 firmware never initializes its RXDMA pipeline and delivers
> no frames to the host -- Including management frames via
> WMI_MGMT_RX_EVENTID, which carry beacons and probe responses.
> 
> Therefore we port over the necessary parts of the following functions
> from the linux ath12k driver:
> 
> ath12k_dp_rxdma_ring_sel_config_wcn7850():
>     drivers/net/wireless/ath/ath12k/wifi7/dp_rx.c
> 
> ath12k_dp_rx_htt_setup():
>     drivers/net/wireless/ath/ath12k/dp_rx.c
> 
> As well we need to disable the 802.11d scanning for now, since the
> command causes a firmware error, for which we currently have no solution.
> This isn't critical for making further progress.
> 
> Ok?
>

Can scan on my Honor. OK kirill@

> 
> Index: sys/dev/ic/qwz.c
> ===================================================================
> RCS file: /cvs/src/sys/dev/ic/qwz.c,v
> diff -u -p -u -p -r1.24 qwz.c
> --- sys/dev/ic/qwz.c	12 Apr 2026 19:52:23 -0000	1.24
> +++ sys/dev/ic/qwz.c	19 Apr 2026 19:21:56 -0000
> @@ -13453,6 +13453,76 @@ qwz_dp_rx_pdev_alloc(struct qwz_softc *s
>  	return 0;
>  }
>  
> +int
> +qwz_dp_rxdma_ring_sel_config_wcn7850(struct qwz_softc *sc)
> +{
> +	struct qwz_dp *dp = &sc->dp;
> +	struct htt_rx_ring_tlv_filter tlv_filter = { 0 };
> +	uint32_t ring_id;
> +	int i, ret = 0;
> +
> +	tlv_filter.rx_filter = HTT_RX_FILTER_TLV_FLAGS_MPDU_START |
> +	    HTT_RX_FILTER_TLV_FLAGS_RX_PACKET |
> +	    HTT_RX_FILTER_TLV_FLAGS_MSDU_END;
> +	tlv_filter.pkt_filter_flags2 = HTT_RX_FP_CTRL_PKT_FILTER_TLV_FLAGS2_BAR;
> +	tlv_filter.pkt_filter_flags3 = HTT_RX_FP_DATA_FILTER_FLASG3;
> +
> +	for (i = 0; i < sc->hw_params.num_rxmda_per_pdev; i++) {
> +		ring_id = dp->rx_mac_buf_ring[i].ring_id;
> +		ret = qwz_dp_tx_htt_rx_filter_setup(sc, ring_id, i,
> +		    HAL_RXDMA_BUF, DP_RXDMA_REFILL_RING_SIZE, &tlv_filter);
> +		if (ret) {
> +			printf("%s: failed to configure rx_mac_buf_ring%d "
> +			    "filter %d\n", sc->sc_dev.dv_xname, i, ret);
> +			return ret;
> +		}
> +	}
> +
> +	return ret;
> +}
> +
> +int
> +qwz_dp_rx_htt_setup(struct qwz_softc *sc)
> +{
> +	struct qwz_dp *dp = &sc->dp;
> +	uint32_t ring_id;
> +	int i, ret;
> +
> +	/* TODO: Need to verify the HTT setup for QCN9224 */
> +	ring_id = dp->rx_refill_buf_ring.refill_buf_ring.ring_id;
> +	ret = qwz_dp_tx_htt_srng_setup(sc, ring_id, 0, HAL_RXDMA_BUF);
> +	if (ret) {
> +		printf("%s: failed to configure rx_refill_buf_ring %d\n",
> +		    sc->sc_dev.dv_xname, ret);
> +		return ret;
> +	}
> +
> +	if (sc->hw_params.rx_mac_buf_ring) {
> +		for (i = 0; i < sc->hw_params.num_rxmda_per_pdev; i++) {
> +			ring_id = dp->rx_mac_buf_ring[i].ring_id;
> +			ret = qwz_dp_tx_htt_srng_setup(sc, ring_id, i,
> +			    HAL_RXDMA_BUF);
> +			if (ret) {
> +				printf("%s: failed to configure rx_mac_buf_ring"
> +				    "%d %d\n", sc->sc_dev.dv_xname, i, ret);
> +				return ret;
> +			}
> +		}
> +	}
> +
> +	for (i = 0; i < sc->hw_params.num_rxdma_dst_ring; i++) {
> +		ring_id = dp->rxdma_err_dst_ring[i].ring_id;
> +		ret = qwz_dp_tx_htt_srng_setup(sc, ring_id, i, HAL_RXDMA_DST);
> +		if (ret) {
> +			printf("%s: failed to configure rxdma_err_dst_ring"
> +			    "%d %d\n", sc->sc_dev.dv_xname, i, ret);
> +			return ret;
> +		}
> +	}
> +
> +	return qwz_dp_rxdma_ring_sel_config_wcn7850(sc);
> +}
> +
>  void
>  qwz_dp_pdev_free(struct qwz_softc *sc)
>  {
> @@ -13479,6 +13549,13 @@ qwz_dp_pdev_alloc(struct qwz_softc *sc)
>  		}
>  	}
>  
> +	ret = qwz_dp_rx_htt_setup(sc);
> +	if (ret) {
> +		printf("%s: failed to setup rx htt %d\n",
> +		    sc->sc_dev.dv_xname, ret);
> +		goto err;
> +	}
> +
>  	return 0;
>  
>  err:
> @@ -21302,6 +21379,12 @@ qwz_init_task(void *arg)
>  void
>  qwz_mac_11d_scan_start(struct qwz_softc *sc, struct qwz_vif *arvif)
>  {
> +/*
> + * XXX:
> + * The 802.11d scanning command is currently causing a firmware error,
> + * hence disabling this function for now.
> + */
> +#if 0
>  	struct ieee80211com *ic = &sc->sc_ic;
>  	struct wmi_11d_scan_start_params param;
>  	int ret;
> @@ -21349,6 +21432,7 @@ fin:
>  	}
>  #ifdef notyet
>  	mutex_unlock(&ar->ab->vdev_id_11d_lock);
> +#endif
>  #endif
>  }
>  

-- 
wbr, Kirill