Index | Thread | Search

From:
Tom Smyth <tom.smyth@wirelessconnect.eu>
Subject:
Re: bgpd: allow quick open on startup
To:
tech@openbsd.org
Date:
Thu, 23 Jul 2026 12:31:24 +0100

Download raw body.

Thread
Thanks Claudio,
replies in line

On Thu, 23 Jul 2026 at 12:20, Claudio Jeker <cjeker@diehard.n-r-g.com>
wrote:

>
>
> This really depends on the remote peer. Also does it take 2-3min before
> the session is established or 2-3min until routes have settled.
>
it takes  2-3 minutes before the session establishes ( it may BGP not
connecting first time round (because OSPF has not converged)  (loopback to
loopback reachability via OSPF, and then BGP multi-hop between the
loopbacks)


> If you rapidly reboot a system multiple times then the IdleHold timer will
> punish your constant flaps and delay connects. For a single reset
> connections should reestablish more or less instantly.
>
It would be one reboot or 2 reboots (upgrade + syspatch)
( it may BGP not connecting first time round (because OSPF has not
converged)  (loopback to loopback reachability via OSPF, and then BGP
multi-hop between the loopbacks)


> With log verbose you should see connection atempts from peers that are in
> state idle. Also show neig X timer is good to see which timers are
> running and for how long.
>
Ill take a look at that ..  it was more just that the interruption seemed
to extend by 2 minutes more than necessary (but it was in maintenance
windows with redundant routers so its impact is low (except for post crash
recovery )

Thanks again

>
> --
> :wq Claudio
>
>

-- 
Kindest regards,
Tom Smyth.