Index | Thread | Search

From:
Yamasaki Yuu <miagetegorann@gmail.com>
Subject:
[PATCH 0/7] Hyper-V Generation 2 guests on amd64
To:
tech@openbsd.org
Date:
Wed, 11 Nov 2026 11:46:45 +0900

Download raw body.

Thread
OpenBSD/amd64 doesn't run as a Hyper-V Generation 2 (UEFI) guest today:
the kernel hangs right after the boot loader hands over, the installer
finds no disks, the virtual DVD can't be read, and there is no keyboard
because Generation 2 VMs have no i8042.  This series fixes that.

The patches are against -current (6afb24b0786) and apply in order with
"patch -p0" from /usr/src.  1/7 is an independent bug fix.  2/7 also
moves the IDE disks of Generation 1 VMs from wd(4) to sd(4).  Installs
that use DUIDs, as the installer sets up, come up normally; an fstab
that names wd devices has to be changed.  Details are in 2/7.

Tested on Windows 11 (build 26300) Hyper-V, firmware Hyper-V UEFI v4.1.
Rebasing from 39ced97e2ed to 6afb24b0786 didn't change the patches.

On 6afb24b0786, with these patches:
 - GENERIC, GENERIC.MP and RAMDISK_CD build without warnings; GENERIC.MP
   also after each patch.
 - Generation 2: MP and SP kernels boot; wscons event and raw keyboard
   input on the console; the whole install ISO read from cd0 with a
   matching checksum.
 - QEMU/SeaBIOS with an AHCI disk (no Hyper-V): the 8.0 install from
   the Generation 1 tests below boots multi-user.

On 39ced97e2ed, with the same changes:
 - pvbus.c, wskbd.c and hidkbd.c compile for i386; wskbd.c and hidkbd.c
   pass the compiler front end for arm64, armv7 and riscv64.
 - Generation 2: DDB entered from the keyboard, "show registers",
   "continue".  Without 3/7, reads from cd0 fail with EIO.
 - Generation 1: an 8.0 install on wd0 (root, swap and fstab by DUID)
   boots as root on sd0a and mounts every fstab entry.  pciide(4)
   reports channel 0 disabled.  The IDE DVD is still cd0 on
   atapiscsi(4).
   With disks at IDE 0:0, 0:1 and 1:1 and SCSI 0:0, each appears once
   as sd0-sd3 with the right size.  Concurrent writes read back
   intact.  The stock kernel shows the IDE disks as wd0-wd2 and
   doesn't see the SCSI disk.
   With a display console pckbd(4) is the console keyboard and
   hvkbd(4) doesn't attach.  With a serial console hvkbd(4) attaches
   next to pckbd(4).
 - With an earlier revision of these changes: Generation 2 install
   from a CD built with its kernels, KARL relinking and reboots, and
   the QEMU/OVMF installer.  Fault injection: rejected keyboard
   negotiation; wskbd(4) disabled with config -e; oversized keyboard
   messages are dropped and input continues (without
   hv_channel_skip() the keyboard stops for good).
   The only changes since then are dropping a Generation 1 IDE
   exception, a comment in 3/7, the hvkbd(4) negotiation timeout and
   an always-true condition in wscn_input_init().  None of them
   affects those paths on Generation 2.

Not tested: other Hyper-V versions, Azure, live migration, saved
state, Secure Boot, and hypervisors exposing Hyper-V enlightenments
(QEMU hv-*, VirtualBox), although detection there is unchanged.

Yamasaki Yuu (7):
  hyperv: revoke ring GPADL before freeing it, don't sleep when cold
  hyperv: attach drivers to channels regardless of monitor notification
  hvs: use 10-byte commands with the Hyper-V virtual DVD drive
  amd64: select the Hyper-V delay function before console probing
  hidkbd: don't claim the console when another keyboard already has it
  hyperv: add hv_channel_skip()
  hvkbd: Hyper-V synthetic keyboard driver

 distrib/sets/lists/man/mi             |   1 +
 share/man/man4/Makefile               |   2 +-
 share/man/man4/hvkbd.4                |  79 +++++
 share/man/man4/hyperv.4               |   4 +-
 sys/arch/amd64/amd64/machdep.c        |   8 +
 sys/arch/amd64/amd64/wscons_machdep.c |   8 +
 sys/arch/amd64/conf/GENERIC           |   2 +
 sys/arch/amd64/conf/RAMDISK_CD        |   2 +
 sys/dev/hid/hidkbd.c                  |   3 +-
 sys/dev/pckbc/files.pckbc             |   2 +-
 sys/dev/pv/files.pv                   |   5 +
 sys/dev/pv/hvkbd.c                    | 436 ++++++++++++++++++++++++++
 sys/dev/pv/hvkbdvar.h                 |  19 ++
 sys/dev/pv/hvs.c                      |  10 +
 sys/dev/pv/hyperv.c                   |  57 +++-
 sys/dev/pv/hypervic.c                 |   3 +-
 sys/dev/pv/hypervvar.h                |   4 +-
 sys/dev/pv/pvbus.c                    |  85 +++--
 sys/dev/pv/pvvar.h                    |   1 +
 sys/dev/wscons/wskbd.c                |   6 +
 sys/dev/wscons/wskbdvar.h             |   1 +
 21 files changed, 706 insertions(+), 32 deletions(-)
 create mode 100644 share/man/man4/hvkbd.4
 create mode 100644 sys/dev/pv/hvkbd.c
 create mode 100644 sys/dev/pv/hvkbdvar.h


base-commit: 6afb24b0786a15a1b41b8bfce97d26a83bbbb508